Blog
Shaft Runout Inspection: Agree the Datum Before Accepting Results
A shaft can pass its diameter check and still wobble in an assembly. Before asking for a tighter machining tolerance, define which surface establishes the rotation axis and where the runout reading must be taken. Shaft runout inspection needs that setup information before supplier and incoming results can be compared.
What a shaft runout measurement tells you
Runout evaluates a surface while the part rotates about a specified datum axis. Circular runout concerns individual circular sections; total runout concerns the controlled surface as a whole. KEYENCE explains this distinction in its runout tolerance guide. A diameter result alone does not establish either requirement. Use the drawing’s governing standard and feature control frame to define acceptance.
Agree the setup before comparing numbers
Ask the inspector to identify the datum features, the fixture or support arrangement, the measured surface and the contact direction. Record the axial measurement locations rather than writing only “runout checked.” A shop-floor check in an arbitrary chuck can help investigate a process, but its reading should not automatically replace acceptance against the specified datum.
| Question before inspection | Evidence to request | Decision if missing |
|---|---|---|
| What establishes rotation? | Datum identification and setup sketch or photograph | Clarify the setup before comparing results |
| Which surface and locations are checked? | Drawing characteristic and measurement positions | Agree coverage before lot release |
| Which requirement applies? | Circular or total runout callout, units and tolerance | Resolve drawing ambiguity with the designer |
| Can the measurement be repeated? | Repeat readings and fixture/instrument identification | Investigate the method before changing the part |
When supplier and incoming results disagree
Compare the two methods before rejecting the lot. Confirm both teams used the same drawing revision and datum interpretation. Check that the specified surfaces are clean and accessible and that the support does not damage the part. Repeat the agreed check after remounting and record what changed. If the setup or instrument is unsuitable for the requirement, refer the result to the responsible quality engineer instead of averaging conflicting numbers.
A change in the reading is a reason to investigate; it is not, by itself, proof of a bent shaft or a supplier error. Keep the affected parts identified while the method and disposition are reviewed.
Runout acceptance checklist
- Released drawing, revision, units and applicable GD&T standard.
- Datum features and the inspection support arrangement.
- Measured surface, direction and required measurement coverage.
- Instrument identification, calibration status and suitability review.
- Recorded results linked to the inspected parts or lot.
- Agreed action for a failed or inconclusive result.
For a stepped shaft, inspect shoulder clearance separately; the shaft shoulder radius guide addresses that assembly problem. Use the inspection report checklist to define the delivery evidence. For a drawing review, send the controlled shaft drawing and inspection requirements to tonyzhou@lxcet.com.
