Blog
Shaft Shoulder Radius: Check Bearing Clearance Before Machining
A shaft diameter can meet its drawing tolerance while the bearing still stops short of the shoulder. Check the shaft shoulder radius against the selected bearing’s mounting dimensions before changing the shaft diameter or applying more assembly force. The bearing’s corner clearance, the shaft transition and the supporting shoulder must work together.
A visible gap is a reason to investigate, not proof of radius interference. A burr, contamination, an incorrect bearing or a dimensional error can produce a similar symptom. Follow the bearing manufacturer’s mounting procedure and identify the cause before altering either component.
Match the shaft shoulder radius to the actual bearing
Use the complete bearing designation and its current mounting table. Record the permitted shaft fillet radius and shoulder diameter, not just the bearing bore. JTEKT’s mounting-dimensions guidance treats fillet and shoulder dimensions as part of the bearing interface and directs designers to the individual bearing specifications. A generic chamfer note on a shaft drawing cannot establish compatibility with every bearing of that bore size.
Review the full transition profile. MinebeaMitsumi’s shaft and housing design guidance for miniature and small ball bearings connects corner clearance with adequate shoulder support and a perpendicular supporting face. Making the radius smaller is therefore only one possible change; it does not resolve an unsuitable shoulder face or an inadequate supporting area.
| Finding | Review before changing the part | Approval evidence |
|---|---|---|
| Bearing stops near the shoulder | Inspect the transition, burrs, bearing identity and mounting conditions | Recorded dimensions and an identified cause |
| Proposed fillet conflicts with bearing clearance | Compare the bearing’s mounting limits with the controlled shaft profile | Approved drawing revision and interface check |
| A relief or spacer is proposed | Review support, axial location, strength and access for assembly | Approved assembly detail and trial results |
Choose a transition that preserves the intended support
JTEKT’s shaft and housing design notes describe fillets, grinding reliefs and spacer arrangements for different conditions. A spacer can accommodate a transition that would otherwise conflict with a bearing corner. That is a design option requiring review, not permission for a machinist to insert a washer into an approved assembly.
For a proposed change, mark the surfaces that locate the bearing and the region that must remain clear. If a relief is selected, define its width, depth and permitted profile. If a spacer is selected, include its material, face requirements and effect on the axial stack in the approval package. Do not remove material at a loaded shaft transition without the responsible designer’s approval.
Specify the manufacturing and inspection stage too. A profile checked before a later finishing operation may not represent the delivered interface. Keep fit diameter, transition geometry and shoulder-face requirements separate; the CNC machining tolerances guide explains why one general tolerance cannot replace feature-specific acceptance limits.
Inspect the interface before releasing the batch
A diameter measurement does not verify the shoulder radius. Agree how the transition profile will be checked and how its results will be recorded. Depending on access and the specified limit, a profile projector, optical measurement or another agreed contour method may be suitable. Confirm that the chosen method can resolve the actual feature; do not select an instrument solely because it is available.
Keep the trial shaft, bearing identification and inspection record linked. Verify seating by the agreed assembly check rather than judging a photograph alone. For an assembly trial, state the mounting procedure, acceptance condition and whether the parts remain suitable for production use afterward.
Drawing and RFQ checklist
- Complete bearing designation and applicable mounting-dimension reference.
- Shaft seat diameter, fit and required surface condition.
- Controlled shoulder transition and permitted relief geometry.
- Shoulder support dimensions and face relationship to the shaft datum.
- Material, heat treatment, finishing sequence and final inspection stage.
- Approved profile measurement method and trial-assembly acceptance criteria.
The flanged drive shaft product example shows related rotational geometry; it is not a claim that this catalog part suits a particular bearing. Review precision CNC turning and inspection planning, then send the shaft drawing, bearing designation and order quantity to tonyzhou@lxcet.com. The interface and feasible inspection scope need confirmation for the specific assembly.
