Blog
Reaming Allowance: Check the Pre-Hole Before Chasing Size
A reamed hole that comes out undersize or with a poor finish does not automatically need another finishing pass. Check the pre-hole first. Reaming allowance must suit the actual material, hole and selected tool; reducing the stock to almost nothing can prevent the cutting edges from working as intended.
Define reaming allowance on diameter
For a cylindrical pre-hole, the allowance on diameter is the intended finished diameter minus the measured pre-hole diameter. Distinguish that value from stock per side. Record the pre-hole result rather than relying only on the drill’s nominal size.
Tool manufacturer Gammons Hoaglund explains in its reaming FAQ that too little stock can lead to burnishing instead of clean cutting, while too much can overload the tool and reduce accuracy. Its guidance also distinguishes surface appearance from dimensional accuracy. Choose the starting allowance from the selected tool supplier’s recommendations for the application, then validate it; no single allowance fits every diameter and material.
Check the evidence before changing the tool size
| Observation | First check | What to record |
|---|---|---|
| Pre-hole is close to finished size | Actual stock against the tool’s intended cutting range | Pre-hole and final readings at named locations |
| Results differ between the entry and exit | Hole preparation, alignment and measurement method | Measurement depths and setup identification |
| Surface looks smooth but fit fails | Drawing requirements beyond appearance | Size, relevant form and assembly observations separately |
| Result changes during the batch | Tool condition and whether the preparation changed | Part sequence, tool identity and process changes |
Run a controlled trial
Give the machinist the material condition, finished-hole requirements and whether the hole is blind, through or interrupted. Ask for the planned pre-hole and the tool supplier’s application guidance. Keep the trial pieces identified. If the process is adjusted, record the change and compare the same inspection characteristics on the next piece.
Do not approve a correction solely because a mating pin now enters. Confirm which drawing characteristics the pin check addresses and which still need measurement. If a hole is already outside its requirement, hold the part for an approved disposition before enlarging it or changing the mating component.
Put the acceptance requirement on the drawing
- Finished hole size, tolerance, depth and applicable datums.
- Required surface texture and relevant geometric controls.
- Whether acceptance applies before or after surface finishing.
- Agreed measuring method and locations.
- Trial results linked to the drawing revision and material lot.
- Approval route for any proposed rework.
For the measurement record, use the inspection report checklist. Specify the finish using the surface roughness guide, rather than a visual description alone. Send the drawing and hole requirements to tonyzhou@lxcet.com for a part-specific review.
