Blog
Galvanic Corrosion in Machined Assemblies: Review the Whole Joint
Consider a bracket that passes dimensional inspection, then develops corrosion around its fasteners after coastal service. The drawing controlled hole position and surface finish but left the assembled joint undefined. Galvanic corrosion in machined assemblies needs a review of the connected parts, not just the alloy of the machined component.
Review three things together: the metal combination, the electrical connection between components and the moisture or other electrolyte reaching the joint. Then define a protection method that remains effective after tightening, service and maintenance. A coating callout on one part does not describe the complete assembly.
Find the electrical path before changing the material
NASA Kennedy Space Center explains galvanic corrosion as an electrochemical process involving dissimilar metals, an electrolyte and an electrically conducting path. Its examples include electrical isolation as a way to interrupt that path. This is general corrosion guidance, not a qualification standard for your component.
Use a joint section to identify every possible contact: the underside of a fastener head, its shank, threads, washers, inserts and the adjacent structure. An insulating washer under the head does not by itself demonstrate isolation of the shank or threaded connection. Also check whether a second bracket or bonding connection bypasses the intended isolation.
For a sailing fitting or an outdoor enclosure, record whether the assembly sees salt spray, rain, standing water or repeated drying. Do not diagnose all visible corrosion as galvanic attack. Retain affected parts and document where the damage starts; deposits, crevices or mechanical damage may need separate investigation.
Galvanic corrosion in machined assemblies: choose controls around function
| Proposed control | Detail to put on the assembly drawing | Question to resolve before release |
|---|---|---|
| Electrical isolation | Locations and materials of sleeves, washers and interface barriers. | Is the path interrupted after tightening, including threads and nearby hardware? |
| Coating or surface treatment | Specification, preparation, masked areas and repair requirements. | What happens at edges, threaded features and contact points during assembly? |
| Moisture control | Drainage, seal placement and accessible inspection points. | Does the detail prevent ingress or create a pocket that retains water? |
| Material change | Revised alloy, condition, mating material and required evidence. | Are load, fit, finishing and service requirements still satisfied? |
These are review options, not interchangeable fixes. If electrical continuity is required for the product, complete isolation may conflict with its function. Have the responsible engineering team define the bonding and corrosion strategy together rather than letting assembly staff choose an insulating component informally.
Check the assembled condition, not an untouched sample
Agree a representative assembly before production. Record the part revision, finish, fastener and isolation components used, plus the approved assembly procedure. Inspect accessible coated surfaces after assembly for damage. Where isolation is a requirement, specify the electrical test method and acceptance criterion; visual inspection alone does not establish it.
When environmental testing is required, define the test method, exposure, assembly condition and failure criteria in the purchase specification. Do not turn an unspecified salt-spray duration into a prediction of service life. A flat coated coupon also does not reproduce every feature of a loaded joint.
Review dimensions after anodizing alongside the joint stack. Coating, washers and sleeves may affect the interface dimensions that determine fit; the drawing should identify the condition in which each critical dimension is accepted.
Joint-review checklist for the drawing package
- List both mating materials, conditions and all fastening hardware.
- Describe the exposure and any required electrical continuity.
- Mark electrical isolation, seals, drainage and coating boundaries on a section view.
- Define the approved assembly process and the checks after assembly.
- Specify any environmental test and its actual pass/fail criteria.
- Agree handling, maintenance and replacement instructions where relevant.
Use the fixture component page to discuss locating and fastening interfaces, and include the mating materials on your own drawing. Send the assembly drawing with the part model when requesting a manufacturing review. Use the inspection planning page to identify the evidence needed at acceptance. Contact tonyzhou@lxcet.com with the mating materials, exposure and critical interfaces; request written confirmation of the project scope.
