Blog
Machined Parts Acceptance Sampling: Agree the Lot Release Rules
“Inspect a few pieces before shipment” is not a usable machined parts acceptance sampling plan. It leaves the supplier and buyer to choose different samples, defect definitions and release rules. A passing report can then conceal a disagreement about what was actually accepted.
Agree the plan before the purchase order is released. It should identify the lot, the characteristics checked, how parts are selected and what happens when a result fails. Sampling supports a lot decision; it does not certify every unmeasured part.
What a machined parts acceptance sampling plan must define
NIST describes a single sampling plan using sample size n and acceptance number c: select a random sample and reject the lot if the number of nonconforming units exceeds c. Those two numbers need an agreed quality and risk basis. They should not be selected simply because five parts fit conveniently in a report. See the NIST explanation of acceptance plans.
ASQ distinguishes attributes plans, which use discrete classifications or counts, from variables plans using continuous measurements. Recording bore diameters does not by itself create a valid variables acceptance plan. The statistical procedure and its assumptions still need to be specified. See ASQ’s sampling overview.
| Purchase-order field | Decision to record | Ambiguity it prevents |
|---|---|---|
| Lot boundary | Part number, revision, quantity and traceable production grouping | Combining unlike production into one release decision |
| Characteristic | Drawing reference, requirement and defect definition | One supplier checking appearance while another checks fit |
| Selection | Random selection method and access to the whole lot | Checking only the top layer of one box |
| Plan | Agreed procedure or standard edition, sample size and decision criteria | Inventing acceptance rules after seeing the results |
| Failure response | Hold, investigation, disposition and authorized release | Repeated sampling until a favorable result appears |
Make the lot accessible and representative
Minitab’s guidance calls for random, representative selection and homogeneous lots. It also recommends agreement between consumer and supplier on target quality levels. For isolated finite lots, the choice of probability model matters; do not transfer a convenient large-lot calculation to every small order. See Minitab’s data considerations.
For a machined delivery, ask how different setups, production dates or finishing batches are identified. Decide with the quality team whether they belong in one lot. Keep that grouping visible on the packing list and inspection record. If parts must be unpacked to reach the selected items, arrange that access before sealing the shipment.
Separate high-consequence features from routine checks
A cosmetic mark and a failed locating bore may have different consequences. List the features that affect safety, sealing or assembly separately. The responsible engineering and quality teams should decide whether those features need additional process controls, individual inspection or another agreed method. Sampling every feature under one informal rule is difficult to defend.
Even individual inspection needs a capable measurement method and clear disposition rules. Avoid writing “100% inspected” as a substitute for identifying which features were checked and how. An inspection report checklist can help define the record, but the order still needs its own acceptance plan.
RFQ checklist for inspection sampling
- Attach the controlled drawing and identify the lot-release authority.
- Define nonconforming units versus individual nonconformities consistently.
- Agree the sampling procedure, applicable edition and risk assumptions.
- State the measurement methods and treatment of borderline results.
- Record selected part identifiers and actual results, including failures.
- Specify segregation, rework, resubmission and concession approval.
Request the inspection scope alongside the unit price. On a component such as the precision test equipment fixture, identify the locating and mounting features individually. Discuss the drawing, quantity and release requirements with tonyzhou@lxcet.com, and use LXCET’s quality inspection page as a starting point. A sampling plan should be accepted in writing for the order; this article does not prescribe a universal sample size.
